Do you look at your lens during cleaning or replacement? Sure, you might look for metal spatter and scratches, but do you know everything that you should be looking for?\u00a0 We know that a catastrophic lens failure can result in thousands of dollars in repairs and replacement parts, along with machine downtime and lost production, but very often this can be prevented. Here are a few things to check for when cleaning or replacing your lens.<\/p>\n
DEBRIS<\/strong>– If you notice spots on your lens, it\u2019s important to determine where they are coming from.\u00a0 Spots or contamination on the top of your lens indicates that you have contamination in your beam delivery system.\u00a0 This can be caused by holes in your beam bellows which allow dirt and debris to enter the beam path and settle on the top of the lens (the lowest point in the delivery system). If you observe discoloration on the top of the lens, especially rainbow coloring, this is the result of contaminated purge gas or air.\u00a0 A rainbow coloring indicates the presence of a petroleum product, and when heated by the laser beam, will quickly deteriorate your lens coating.<\/p>\n Metal spatter or spots on the bottom of the lens is common, and is usually the result of incorrect piercing or cutting conditions.\u00a0 Utilizing full power piercing on thick material, piercing too close to the plate, not having enough piercing pressure or not using the correct focus position can all result in reduced lens life due to spatter.\u00a0 Discoloration on the bottom of the lens can be the result of contaminated assist gas, shop air, or humidity.\u00a0 Just as with the top of the lens, these contaminates will quickly breakdown the lens coating and will result in reduced lens life or failure.<\/p>\n LENS CHIPS<\/strong>– Lens chips or galling, especially around the perimeter, are the result of lens mating surface having a burr or contamination.\u00a0 This can be identified by running your finger along both mating surfaces, and corrected by carefully buffing the problem area and removing any debris.<\/p>\n HEAT DISTRIBUTION<\/strong>– Uneven heat distribution in a lens can be the result of improper beam alignment or uneven beam mode.\u00a0 Uneven heat distribution within a lens can be seen only under polarization.\u00a0 By placing Mate polarizing filters (MLN01105 \u2013 1.5\u201d, MLN01106 \u2013 2.0\u201d) in front of and behind a lens, and moving them back and forth between parallel and perpendicular positions, lens stress will show as bright yellow streaks.\u00a0 A lens with a lot of these streaks is almost certain to fail, and should be replaced immediately. Correcting a heat distribution problem usually requires a service technician with specialized training to adjust the beam mode, and perform a beam alignment.<\/p>\n","protected":false},"excerpt":{"rendered":" Do you look at your lens during cleaning or replacement? Sure, you might look for metal spatter and scratches, but do you know everything that you should be looking for?\u00a0 We know that a catastrophic lens failure can result in thousands of dollars in repairs and replacement parts, along with machine downtime and lost production, […]<\/p>\n","protected":false},"author":21,"featured_media":29903,"comment_status":"closed","ping_status":"closed","sticky":false,"template":"","format":"standard","meta":{"_acf_changed":false,"_monsterinsights_skip_tracking":false,"_monsterinsights_sitenote_active":false,"_monsterinsights_sitenote_note":"","_monsterinsights_sitenote_category":0,"footnotes":""},"categories":[7146],"tags":[],"class_list":["post-36320","post","type-post","status-publish","format-standard","has-post-thumbnail","hentry","category-laser-technologies-pl"],"acf":[],"yoast_head":"\n