Red Dot Corporation
SPRING-LOADED LOUVER TOOL INCREASES PRODUCTIVITY 68%
Red Dot Corp., a global manufacturer of HVAC systems for heavy trucks, heavy equipment and military vehicles, was having trouble producing a louvered part efficiently. The process incurred a lot of excess manual handling, which in turn led to a lot of poor-quality parts. So, when Mate Sales Engineer John Nugent asked Red Dot’s production programmer Jericho Abad if he was experiencing any problems, Abad mentioned the louver issue.
EXCESSIVE MATERIAL HANDLING.
Nugent worked closely with Abad to better understand the situation. Red Dot was cutting a one large sheet of galvannealed steel into 5 smaller pieces. These smaller sheets were loaded on to their punch press to create blanks and holes. The individual blanks were then removed from the skeleton and reloaded into the punch press to form the louvers. During this part of the process, some individual parts were reloaded backwards or secured in the clamps. The louver tool itself wasn’t spring loaded. It could stick out about 0.35” (8,89mm) and catch the sheet, which in turn could be ripped from the workholders. What’s more, the tool formed the louvers progressively, which was very slow.
Taking Abad’s suggestions into consideration, Nugent worked with Mate’s Application Specialists. They developed a louver tool with a spring-loaded lower, which reduced the load the punch had to absorb. The spring-loaded lower also provided a flat surface to eliminate the possibility of catching the sheet. As a result, Red Dot can load a regular size sheet on the punch press to form all the louvers at once without fear of damage or catching.
FROM TWO-STEPS, 8 HOURS TO ONE STEP, 2.5 HOURS.
Red Dot went from a two-step, eight-hour process to a one-step, 2.5-hour process by using the spring-loaded louver tool. Jericho Abad said that Red Dot’s “productivity with the new Mate louver tool increased 68% without the hassle of finding use for the new remnant material.” The new tool allowed them to eliminate the cutting process, as well as the loading and unloading of sheets, parts and skeletons. It further eliminated remnants from the cutting process. In fact, Red Dot was able to get better sheet utilization due to improved sequencing because they can punch farther into the corners.
Abad is impressed with the results, saying “We just basically set it up, go home and come back in the morning. All we have to do is remove the parts from the punch table.”
Adapted from the article “A New Approach to Forming Louvers,” Dan Davis, The Fabricator, August 2019.