Improve Efficiency with Special Shapes in an Auto Index Station

Solution Bulletin


The Problem: nibbling-eng

Fabricators are always looking for ways to improve manufacturing efficiency in today’s cost conscious environment. Some processes are more obvious than others. One of the most inefficient fabrication techniques that’s frequently overlooked is nibbling large holes with a small punch. To illustrate, the parts shown at right were nibbled using a smaller diameter round punch. While nibbling works, this type of processing causes the following problems:Quad_rad

  • Punching debris that scores and burrs turret bores
  • Increased galling on punches
  • Increased production time for parts (many hits)
  • Increased machine maintenance (side loading)
  • Excessive tool wear that leads to more frequent maintenance and replacement
  • Wear and tear on the machine
  • Scalloped edges

There is a better, more efficient way.

The Mate Solution:

Most turret presses include an auto-index station that rotates a punch and die to any designated angle dictated by the machine program. Mate offers a wide range of special shapes that can be used in the auto index station to improve manufacturing efficiency and product quality. This Solutions Bulletin looks at three high value shapes: Quad Radius, Inside/Outside Radius and Banana Tool.i-o_radius_eng

Quad Radius

Using a punch and die with an arc for a much larger circle, your auto index station can create a smooth edged, round hole limited only by your sheet size. The Quad Radius tool (right) produces large holes with smoother edges and with far fewer hits than using a round nibbling punch. In effect, the Quad Radius tool puts an 8, 12, 16 and 20-inch punch into a single 2-inch station. It will create even larger holes, but as hole size exceeds a tool radius, scalloping begins to appear.

Fully Guided tooling is recommended because the positive guiding action gives the punch the support it needs for nibbling and the stripper clamps the sheet securely to prevent lateral movement. You can order any custom radius you wish.

Inside/outside Radius

This Inside/Outside Radius tool is for use in Auto Index Stations. The inside radius must be larger than outside radius. This tool can be programmed to punch holes with slugs or parts retained in the sheet, yet can be separated easily off the press.banana-samples

The tool’s large radii result in slugs with smoother edges, produced with far fewer hits than using an ordinary radius punch for nibbling holes. This one tool punches slugs of any size practical for its configuration. The smoothest edges occur when the radius punched and tool radius coincide.i-o_centerline

With an Inside/Outside Radius tool, you do not have to stop the machine to remove the slug for an oversize opening, or remove the blank if saving the slug. By using small, precise tabs, the machine does not need to be stopped to remove a slug for an oversize hole. The precise tab is created by leaving a .015”(0.40mm) gap between hits. Once the sheet is removed from the machine, you can still break away the tabs and slugs.

banana-eng

Banana Tools

Similar to Inside/Outside Radius tool, Banana Tools allow fabricators to use the inner part to nest smaller parts. “Obround” banana tools may be more effective in thicker material because, unlike the inside/outside radius tool, there is no sharp point that could break.

Potential Industries That Could Use These Tools

Aerospace Food Service Equipment/Refrigeration
Appliances Heavy/Agricultural Equipment
Automotive HVAC (Heating/Ventilation/Air Conditioning)
Electronic Enclosures Many More!

Available Tooling Styles

  • Thick Turret
  • Thin Turret
  • Trumpf Style
  • Murata Wiedemann
  • Salvagnini